Slash & Pivot as well as Spread can now keep already detached polygons of a patternpiece, allowing continuous Slashing, even without any pleats...
Notice the new "Drag Select", if you multiple slash lines...
Re: In Progress 1.0.146
Posted: Sat Nov 14, 2020 10:52 am
by TiesOli
Trimming of multiple lines with the new "drag select" is pretty fun, too...
Re: In Progress 1.0.146
Posted: Sat Nov 14, 2020 11:01 am
by TiesOli
AND, while we're at it, here's another improvement of Extract and its handling...
Watch the mouse button use! Once you have activated the Extract button, you can click Left Mouse Button to start recording and then continue to click left on the areas you wish to extract. Once you're happy, click the Right Mouse Button to finish the recording and generate the new patternpiece.
As long as the Extract button is active you can continue to do that without having to jump around on the interface.
Re: In Progress 1.0.146
Posted: Sat Nov 14, 2020 3:13 pm
by Meka Adediran
These are wonderful improvements and additions.
I have watched the demos over several times - cant wait to get my hands on it!
I can see my drafting with be much faster now.
Well done Taron & Olivera and thank you for your dedication to making this the best pattern drafting CAD ever
Re: In Progress 1.0.146
Posted: Sat Nov 14, 2020 3:31 pm
by TiesOli
from Olivera from me
We're doing one final testing round and then prepare the release!
Re: In Progress 1.0.146
Posted: Mon Nov 16, 2020 12:21 am
by AthenessaDesigns
I am so d*mn excited about this. You guys are rockstars!
from Olivera